Your Complete Plumbing Winterizing System made in Canada

Canada

 

 


SHUT-DOWN PROCEDURE

Step by Step Instructions
PLEASE READ ALL INSTRUCTIONS BEFORE USE

SHUT MAIN WATER SUPPLY OFF AND WINTERIZE ANY EQUIPMENT (ie. Pump, pressure tank, softeners,etc.)AS YOU WOULD NORMALLY.

DRAIN HOT WATER TANK; Follow these instructions;
Refer to Hot Water Tank Drawing – Then close valve #1, 2, 4, 5 & 7

Shut power supply or fuel source off to Hot Water Tank

 

Connect a hose to the drain valve on Hot Water Tank and open drain, draining to a safe location, open valve #3 to allow air into Hot Water Tank to prevent air lock.

Flush each toilet allowing the tank to empty, then shut cold water supply valve off at each toilet.

 

CLOZER OPERATION MANUAL

  1. Remove lid on “The Clozer” and fill plumbing antifreeze reservoir with non-toxic plumbing antifreeze.

  2. IMPORTANT:  Always check the level of plumbing antifreeze in “The Clozer” reservoir during this winterizing procedure and add accordingly to keep it topped up.

  3. Connect antifreeze outlet on right side of “The Clozer” device to inlet valve on plumbing system, leaving the inlet valve on system closed (Valve #7) (see Figure 1 below)

  4. Connect power connection on right side of “The Clozer” to 115V outlet with extension cord plugged into wall receptacle.

  5. “The Clozer” pump will automatically start and run until approximately 60 psi is obtained.

  6. Check that all faucets in cottage, etc. are in closed position

  7. Connect jumper hose (#6) between valve #4 & #5 and tighten until snug (see Figure 1below)

  8. Open valves #4 & #5 that the jumper hose is connected to (see Figure 1below) allows Hot & Cold water lines to be tied together allowing antifreeze into both simultaneously.

  9. Open valve #7, connecting “The Clozer”. (see Figure 1 below)

  10. “The Clozer” pump should re-start and run until 60 psi is obtained and shut off - pressurizing your system.

  11. Proceed to every faucet and for each one, run the cold faucet until solid pink is observed, then shut off.  Repeat on the hot faucet and run until solid pink is observed.  (You will observe water first and then solid plumbing antifreeze color runs pure)

  12. Repeat Step 11 at every faucet, bathtub, and shower (anywhere you draw water from) throughout thebuilding and outside taps as well.

  13. After all faucets are complete, open the cold water supply valve at the toilet and flush.When you observe that solid pink is entering the flush tank on the back of toilet, close the valve on the water supply to the toilet tank as you do not need to fill the tank completely with plumbing antifreeze.  Bail water from toilet bowl and add plumbing antifreeze (as you do normally)

    NOTE:  some low flush toilets retain a substantial amount of water after flushing and this may need to be bailed out or sponged out of tank so as not to dilute the plumbing antifreeze.

  14. If you have a dishwasher be sure to start dishwasher on shortest wash cycle and allow it to complete this cycle, allowingthe  water supply line, solenoid and also the discharge pump to be filled with plumbing antifreeze.

  15. Proceed to clothes washing machine and set dial to COLD water only, turn machine on until solid pink is observed in washing machine drum and shut off washing machine.  Repeat this by setting dial to HOT water only, turn machine on until sold pink is entering drum and shut off washing machine.  Repeat again by setting dial to Hot/Cold WARM setting and turn on machine allowing approximately one litre of plumbing antifreeze to enter the drum.  Advance to pump out cycle to winterize washing machine pump.

NOTE:  If you do not observe plumbing antifreeze from both the Hot & Cold settings then either the Hot or Cold water line, respectively, may have a plugged screen and that waterline will not be protected from freezing as it did not allow plumbing antifreeze to displace the water in the water line.  (Refer to Washing Machine operating manual)

NOTE:  Refrigerators with Ice & Water dispensers – Refer to owner’s manual.  Waterlines servicing this equipment may be winterized by simply drawing water or allowing equipment to call for ice maker to start, until solid pink is observed.

NOTE:  “The Clozer” puts antifreeze into every water outlet and drain that you physically draw water from during this winterizing procedure.  Make sure that you have protected every water outlet & drain within your building.

NOTE:  All main water supplies (ie. Pumps, pressure tanks, etc.)and any specialty filtration or water treatment equipment should be winterized as you would normally, following themanufacturer’s instructions.

Hot Water The Clozer



HOW CAN WE HELP YOU WITH YOUR INSTALLATION OR WITH ANY QUESTIONS OR CONCERNS THAT YOU HAVE?

We have established a toll free number  1-855-592-5888 for you to contact us during business hours.  We can also be contacted by email info@theclozer.ca

Please don’t hesitate to contact us either before or after you purchase “The Clozer”

 Clozer Facebook Clozer_Tweet

 

The Clozer is capable of closing your RV, Camper, Boat, Cottage or Home.
Call today for personal quotation - 1-855-592-5888, info@theclozer.ca